Why is Wireless N WiFi Repeater Reset Not Working?
Resetting the Wireless N repeater, although an easy job, can be a mess sometimes. Many users get stuck. The repeater won’t reset even after trying for multiple times. Are you also facing a similar problem? If your Wireless N WiFi repeater reset is not happening then you can try the troubleshooting steps highlighted in this post. They were helpful when I got stuck. I could not restore the default settings on my repeater. But after a lot of research, I got some tips which when used helped me reset my device. So I decided to pen down those tips for other users to get help from.
Wireless N WiFi Repeater Reset Failed: Solution!
There is a series of steps that you must try. But before you go through them, check that you are trying to reset your repeater using the right button. The Reset button usually is located inside a hole labeled Reset or Factory Reset. Now, read the steps given ahead one by one and analyze what is stopping you from getting your repeater reset. Let’s begin!
Are You Using the Correct Reset Steps?
We shall start by explaining the exact reset steps. We recommend you skim through the instructions and see if you are using the same procedure or not. Here is how to reset your Wireless-N WiFi repeater:
- Check that the repeater is properly booted up.
- With the help of a sharp pointed object to push and hold the Reset button for at least 15 seconds.
- Unhold the button and the repeater will be running on the default values.
Are you using the same steps? Try to reset your repeater now.
Is the Power Supply to the Repeater Adequate?
The Wireless N repeater should be properly powered up when you are resetting it to the factory settings. So, you must verify the electricity supply to it. Check the power outlet and the power cable. None of these should be damaged. A loose power cable can also be the reason. You can put to use a UPS if the power supply is fluctuating.
Press the Reset Button for a Longer Time
Maybe you are not holding the Reset button for a sufficient amount of time. This is a possible reason. This is one of the reasons why I could not perform a Wireless N WiFi repeater reset. So, while resetting your repeater, push and hold a little longer than before. Better keep a watch by your side and then push and hold the button. This should be helpful in resetting your repeater.
Reboot the Repeater and then Reset
If the reset issue persists even after all the above given tips, then you should reboot your repeater once and then try to reset it to the factory settings. This very step helped me. All I did was restart the Wireless-N WiFi repeater which fixed some technical glitches. To reboot your repeater, power it off by toggling the Power button. Unplug the power cable. Wait for some time and then again switch on the repeater.
After the repeater boots up completely, you should try the reset process once again. Make sure the power supply is stable and you are pressing the Reset button properly for enough amount of time.
Set Up the Wireless N WiFi Repeater
We are anticipating that the repeater is now running on the factory settings. You should now set it up once again. Wireless-N WiFi repeater setup instructions for the WPS method are highlighted below for your assistance:
- Place the repeater and the host router close to each other.
- Switch on the Wireless N repeater now.
- Find the WPS button on the repeater and press it carefully.
- Within two minutes, press the WPS button on the router.
- If your router supports a 5GHz WiFi band, then repeat the same steps once more.
Your repeater is now set up using the WPS method.
Verdict
We are sure that this guide has proved to be fruitful in resolving the Wireless N WiFi repeater reset not working issue. After resetting and setting up the repeater once again, you can move it to a new location in your home and connect to its WiFi on client devices.